Impulse MAQ20-940 User Manual Manuel d'utilisateur télécharger pdf (Page 17)

ReDAQ

Shape Software for MAQ

20 User Manual

Click on the [Save] button to save the changes. The system configuration is now stored in the

COM module nonvolatile memory and I/O modules will be shown in the same slots for all

subsequent power cycles.

Setup COM Tab:

Communication Parameters such as Slave ID, Serial Baud Rate, Parity, IP address and Subnet

mask are modified using this panel. Click on the [Save New Settings] button to store changes in

the COM module nonvolatile memory. Changes made to the communications settings do not

take effect until the system power has been removed and restored.

Real Time Clock: Click on the [Set RTC] button to edit the real time clock settings. Click on the

[Set RTC] button again to send the changes to the module.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 70 71

Pas de commentaire

Impulse MAQ20-940 User Manual Manuel d'utilisateur Page 17